Re: [SilverStreak] (Fwd) Help re Removing toilet platform

["Richard Closson" <clossonmbs@xxxxxxxxxxxxx>]

Eddie,
I am not familiar with offset flanges.
A couple of years ago, I had Inca Plastics, (909-923-3235) in Ontario, CA., 
replace the air vent fitting in the top of my tank by 'welding' in a new 
square of plastic with the new fitting. Maybe you can have a new flange 
fitting repositioned on your tank to accommodate the offset. My old tank 
continued to develop cracks and I had to have a new tank custom fabricated.

----- Original Message ----- 
From: "Eddie" <Eddie@Huffstetter.com>
To: <sslist@tompatterson.com>
Sent: Thursday, May 01, 2008 11:36 AM
Subject: Re: [SilverStreak] (Fwd) Help re Removing toilet platform


> Richard,
> I have still not found that flange in a 10" center to 11" center (off the 
> wall) old-style offset. I still cannot install my new china toilet on the 
> perfect floor. The current toilets are all 11" center off the wall. The 
> 60's were on 10" center. To change the holding tank for only one inch is 
> prohibitive. The conversion offset used to be so common and available. Now 
> I cannot find it. All available offsets are about 3 inch.
> -Eddie-
> Houston, TX
>