The Silver Streak E-mail ListArchive Files[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [SilverStreak] SS sabre logo casting
Ok, lets go with Darwin's intact logos. What I will do is go by the casting company today, and ensure that they will still do this sort of thing. I will get back to you later today with a confirmation. At that point, you can send them to me at: 9123 McAfee Drive Houston, Texas 77031 Thanks, Tom ----- Original Message ----- From: "Darin Unthank" <darin@multi-pak.com> To: <sslist@tompatterson.com> Sent: Monday, June 02, 2008 11:04 AM Subject: RE: [SilverStreak] SS sabre logo casting > Tom- > > I'm in Los Angeles county, San Fernando Valley. I will UPS them to you. > Send me your address. My e-mail is darin@multi-pak.com > > Regards, > > Darin > > -----Original Message----- > From: sslist-admin@tompatterson.com > [mailto:sslist-admin@tompatterson.com] On Behalf Of Tom Patterson > Sent: Monday, June 02, 2008 8:53 AM > To: sslist@tompatterson.com > Subject: Re: [SilverStreak] SS sabre logo casting > > Hi Dan, > > If your logos are fully intact, they may work a little better than > Patti's > logos. > > Where are you located? > > -Tom > > ----- Original Message ----- > From: "Darin Unthank" <darin@multi-pak.com> > To: <sslist@tompatterson.com> > Sent: Monday, June 02, 2008 10:37 AM > Subject: RE: [SilverStreak] SS sabre logo casting > > >> Tom: >> >> I have both the Silver Streak logo (1967) and the Sabre logo that are > in >> good shape. I can send these to you. >> >> -----Original Message----- >> From: sslist-admin@tompatterson.com >> [mailto:sslist-admin@tompatterson.com] On Behalf Of Tom Patterson >> Sent: Sunday, June 01, 2008 4:52 PM >> To: sslist@tompatterson.com >> Subject: Re: [SilverStreak] SS sabre logo casting >> >> Anyone in the Houston area who has some logos I can borrow in order to >> have >> a mold made up? If both front and back are the same size, then only > one >> >> logo is needed. >> >> -Tom >> >> ----- Original Message ----- >> From: "Bev Harris" <zia@ix.netcom.com> >> To: <sslist@tompatterson.com> >> Sent: Sunday, June 01, 2008 6:49 PM >> Subject: Re: [SilverStreak] SS sabre logo casting >> >> >>> I'm interested too for my 64 Sabre. >>> Bev >>> >>> On 1 Jun 2008 at 17:04, Tom Patterson wrote: >>> >>> >>>> I should be able to get some of these cast here in Houston if there >> is >>>> any >>>> interest. >>>> >>>> I had some Streamline ones done in aluminum, and they turned out >> well. >>>> >>>> I would need to borrow some existing logos for the casting company > to >> use >>>> to >>>> make up molds. >>>> >>>> Any interest? >>>> >>>> -Tom >>
|