RE: [SilverStreak] SS sabre logo casting

["Darin Unthank" <darin@xxxxxxxxxxxxx>]

Tom-

I'm in Los Angeles county, San Fernando Valley.  I will UPS them to you.
Send me your address.  My e-mail is darin@multi-pak.com

Regards,

Darin

-----Original Message-----
From: sslist-admin@tompatterson.com
[mailto:sslist-admin@tompatterson.com] On Behalf Of Tom Patterson
Sent: Monday, June 02, 2008 8:53 AM
To: sslist@tompatterson.com
Subject: Re: [SilverStreak] SS sabre logo casting

Hi Dan,

If your logos are fully intact, they may work a little better than
Patti's 
logos.

Where are you located?

-Tom

----- Original Message ----- 
From: "Darin Unthank" <darin@multi-pak.com>
To: <sslist@tompatterson.com>
Sent: Monday, June 02, 2008 10:37 AM
Subject: RE: [SilverStreak] SS sabre logo casting


> Tom:
>
> I have both the Silver Streak logo (1967) and the Sabre logo that are
in
> good shape.  I can send these to you.
>
> -----Original Message-----
> From: sslist-admin@tompatterson.com
> [mailto:sslist-admin@tompatterson.com] On Behalf Of Tom Patterson
> Sent: Sunday, June 01, 2008 4:52 PM
> To: sslist@tompatterson.com
> Subject: Re: [SilverStreak] SS sabre logo casting
>
> Anyone in the Houston area who has some logos I can borrow in order to
> have
> a mold made up?  If both front and back are the same size, then only
one
>
> logo is needed.
>
> -Tom
>
> ----- Original Message ----- 
> From: "Bev Harris" <zia@ix.netcom.com>
> To: <sslist@tompatterson.com>
> Sent: Sunday, June 01, 2008 6:49 PM
> Subject: Re: [SilverStreak] SS sabre logo casting
>
>
>> I'm interested too for my  64 Sabre.
>> Bev
>>
>> On 1 Jun 2008 at 17:04, Tom Patterson wrote:
>>
>>
>>> I should be able to get some of these cast here in Houston if there
> is
>>> any
>>> interest.
>>>
>>> I had some Streamline ones done in aluminum, and they turned out
> well.
>>>
>>> I would need to borrow some existing logos for the casting company
to
> use
>>> to
>>> make up molds.
>>>
>>> Any interest?
>>>
>>> -Tom
>