[SilverStreak] on the magnet latches

["Eddie" <Eddie@xxxxxxxxxxxxxxx>]

Joe,
Generally if the magnet catches are not broken at the mounting tabs, you 
never have to replace. Likely the tabs will break as you try to drill the 
rivets, or when you re-fasten. Just put some duct tape on the ceiling after 
affixing to a doubled paper towel. Use this as a spray shield and just flood 
them and jiggle while spraying with WD 40. Use it as a rinse with drip and 
spray catching towels strategically placed on the cabinets and floor.

Save all that work. Spray, wiggle, jiggle, and spray some more until the 
little magnets get loose, floppy, and independent in the plastic holder. You 
are simply spray-washing with WD 40, a mild solvent soap substitute. You 
will see it works. The WD eventually will evaporate it after finishes 
dripping. Mild Dawn or Dove will clean up around it and the ceiling. Rinse 
with rather wet terry towel and wipe dry.

If you can get so loosened, the pair of independent moving magnets can flush 
contact the metal latch, the magnet set will hold the door.
-Eddie- Houston, TX

------------------------------------------------------------------
When replying to a message, please delete all unnecessary original text.

To unsubscribe or change to a digest format, please go to
http://www.tompatterson.com/Silverstreak/List/listoffice.html