Re: [SilverStreak] lets get serious about this hinge problem

["Bussiere, Curtis L SFC RET" <curtis.bussiere@xxxxxxxxxxx>]

Thanks Tom you are correct. If a quality set of drawings exist then thats what shops will want. 

----- Original Message -----
From: Tom Patterson 
Date: Wednesday, June 4, 2008 17:46
Subject: Re: [SilverStreak] lets get serious about this hinge problem
To: sslist@tompatterson.com

> I don't think Curtis has any new hinge. He is proposing that <BR>> someone send 
> the drawings that Scott has to the outfit in Illinois and see what 
> they will 
> charge.
> 
> -Tom
> 
> ----- Original Message ----- 
> From: "Eddie" 
> To: 
> Sent: Wednesday, June 04, 2008 5:38 PM
> Subject: Re: [SilverStreak] lets get serious about this hinge problem
> 
> 
> > Curtis,
> > Ok, can you send them one of your new hinges? I will gladly 
> share in the 
> > total mailing cost if they will promise return of your NOS hinge 
> to you. 
> > We have a problem. We need hinges. A hinge in hand is what he 
> would best 
> > need isn't it? We want to specify the hinge in stainless, like 
> yours. The 
> > problem is cost. I cannot spend $1500 on three sets, a total of 
> 6 hinge 
> > sets. It is just too much for me.
> >
> > Thank you for this post, especially since you have worked so 
> hard on this 
> > for the members, and already met your personal needs. I am very 
> > appreciative.
> >
> > I am a little confused by the post, but that is unimportant. If 
> Braun has 
> > an interest, wants to do it, then by all means let's get it to 
> them and 
> > get it done. They should be pleased at a captive market.
> > -Eddie-
> > Houston, TX
> >