[VAL] Re: VAL Digest V2 #86

["maych@xxxxxxxxxxx" <maych@xxxxxxxxxxx>]

I had a 1970 model with the same problem, I solved mine by breaking out the 
inside window, this must be done carefully, first I removed the plastic 
shroud around the glass, using an electric drill I started drilling a 1/8" 
hole at the bottom corner of the inside glass, drill at a low speed, the 
drill is used to weaken the glass at that spot, the drilling will take some 
time because they are not made to drill glass, the drill will make an 
indentation in the glass, using a center punch with a point smaller than the 
hole tap lightly until the glass shatters, be careful of flying glass. after 
glass is cleaned up I used caulking to fill the gap between the remaining 
glass and frame, after caulking dries replace the plastic shroud.