[VAC] Re: PJM-> 63 dump valve

["J.Evans Woodward III" <broev@xxxxxxxxxxxxx>]

Chris,
I took the valve apart this morning. There are three gaskets.
one is an o-ring should be readily available
two is a rectangular gasket cut from a flat sheet (no problem)
three is a flat circular gasket (no problem)
When I cut mine I'll cut you some extras.
The difficult part of my rebuild will be the blade. The tip of my blade is
bent and the upper sealing surface is scarred. It is made of brass. I'm
going to try to flatten the end and fill and resurface the top of the blade.
I'll keep you informed.
Evans,
62 sov