Re: [SilverStreak] replacing a floor in the Silver Streak

["Eddie" <Eddie@xxxxxxxxxxxxxxx>]

Jason,
I've not done your early model. Have not done SS. All are hand-made and thus 
each has differences. Have done Streamline and others like Schult. Don't 
think you need to pull exterior panels and suggest you don't. Suggest doing 
sections at a time. Yes use marine and none other. You will have to remove 
old fasteners along perimeter channel into floor as you go. Put aluminum 
paint on foundation structure as you go. You don't have to work yourself to 
death prepping those before painting. Rattle can and brushing aluminum paint 
works good. More is better. You probably need 3/4 and not 5/8.

Try to take pictures B4 and after. I would like to see. Use blue tape or 
other marking labels to keep up with your panels. When reinstalling panels 
use temporary #8 or #6 Phillips screws to align before tightly riveting. Use 
huge card board patterns for radius ends if floor too bad for pattern.

A big tough hard job that will be so rewarding. I'm in your corner and 
cheering you on.
-Eddie-
Houston, TX