Re: [SilverStreak] Cimg3058.jpg;Cimg3056.jpg;Cimg3055.jpg

["Thomas Williams" <tgwilliams204@xxxxxxxxx>]

Ralph, The hinge installation was pretty simple,with Eddie"s
instructions,the first hinge was a little slow,the second much faster. When
riveting the hinges to the doors,the rivets that go on the outer edges of
the doors cannot be installed with the doors closed. The rivets are too
long. I riveted the two inside rivets(the rivets that go into the hollow
section of doors) removed the duct tape,opened the door and riveted the
outer edges of the door. I"m very pleased with the hinges, no sag,or play in
the doors at all. My suggestions, follow eddie"s instructions,go slowly,use
a lot of duct tape,and be very careful with  the tape that Eddie sent,it"s
very sticky. Oh yes,don"t forget the beer.   Good luck.    Tom

----- Original Message -----

> Thomas Williams,
>
> For the edification of all of those who purchased a set of the new
Stainless
> Steel Hinges for their Silver Streaks:
>
> Did the instillation go smoothly?
> Did you have any issues that needed to be addressed?
> Did you follow Eddies installation guide?
> Any suggestions, recommendations or cautions for others installing the new
> Silver Streak Hinges?
>
> Best regards,
>
> Ralph Cooke
>