Hi Chris:
You can use the Olympics without the shaver, especially if you are only
talking about a few. After pulling up the rivet, cut off the shank as close
as you can with a side cutter. Then take your Dremel tool with a sanding
drum installed on it and carefully knock of the rest of the shank until it
blends in with the round cap of the rivet. It won't be as good as the
shaver could do, but if you are careful, it will be PD good. And
undetectable if you don't look close. Remember to take off the EPDM washer
so the head lays down nice and flat.
GQ '67 Safari
4082 in CA