The following notes were enclosed with Jim's pictures:

Photo #1 - a shot of the floor I made up the parquet using South 
American Balsam with borders of Purple Hart and Maple. 
The border is made from Cocobola and maple. 
The floor is 1/8 in thick and is bedded down in 3/4 oz fiberglass 
matte and epoxy the finish is 1 layer of 4 oz fiberglass cloth and
epoxy forming a seamless floor.

Photo #2  - is a shot showing the built in microwave and parquet 
panel doors all interior is in walnut.

Photo #3 - shows the Kenyon hot plate it is either 120 volt or 
alcohol (a marine stove)

Photo #4 - shows the deep freeze mounted under the hot plate

Photo #5 - shows the fridge mounted under the sink cabinet. 
The top is Rosewood parquet treated the same as the floor

Photo #6 - Shows the control panel. All breakers switches and 
remote starter for the generator

Photo #7 - Shows a shot through the center bedroom and the 
panel door to the bath. Note the grill and kitchen cabinet doors. 
The doors are being replaced with doors to match the upper cabinet 
doors.

Photo #8 - A shot into the bath. It was an all fiberglass work 
looked like he used a chain saw to fit it in trimmed out bath in 
walnut

Photo #9 - The Silver Albaltross at home

Photo #10 - This is a work in progress so far I have replaced the 
bathroom floor, made a split holding tank 45 gal,  replaced the belly
pan, checker the frame and repainted it, new tires, new awning 
canvass, new electric hot water tank, rerouted the wiring, 
changed all lights with florescent, sealed the wheel wells and 
end panels to match the upper cabinet doors. Am going to make a
pair of futons and probably build in a radio and cd player.