Re: [VAC] Introduction

[Paul Farley <farley@xxxxxxxxxxx>]

Bill & Fred,
I followed the instructions on Bud Coopers hints from the VAC page.  I
purchased directly from Hehr.   I trimmed off the back 1/8"  L shape then used
a small bead of silicone against the glass (hidden by the vinyl)  and pushed
the vinyl in place.  Ran a small bead  of silicone along the mitre at the
edges.  I used masking tape to hold it tight to the glass while the silicone
set up   I have no leaks and it looks good.  Takes about 10minutes per length
applied.  Try not to use excessive amounts of silicone as it's a pain to clean
off the glass.   If you oops, let it dry and scrape off w/ razor blade.
Hope this helps.
Fred nice to have you here.
Paul