 |  |
 |  |
Posted by Tom Patterson on October 25, 2000 at 08:37:01:
In Reply to: Re: Wiring diagram posted by Tom Patterson on October 24, 2000 at 19:54:24:
Carl,
Here are some pictures which may show what James and I are talking about: Click on any image for a larger copy of that picture.
The first picture shows the 30 gal. fresh water tank and surrounding area. All of the cable you see is because some previous owner had spliced an extension cord to the existing power plug-in, so that now the trailer has miles and miles of cable.
The pipe in the center running off to the right is the vent pipe. The copper pipe at the top is the water inlet pipe. It leads to a line which supplies the rest of the trailer with water, and is connected to the outside inlet.
Picture number two is a close-up of the same area. It shows the electrical converter boxes, as well as the door to the outside through which the hook-up cable is run.
The third picture shows the top of the tank. This is where the valve for draining the tank and the rest of the trailer water lines is located. The valve is up against the wall next to the heating duct. When the valve is opened, the water will drain through the hose to the left of the valve, which goes down through the trailer floor.
Last, the fourth picture is taken from the other side of the wall, from within an adjoining closet. Here is the heat duct coming through the wall, and next to it, the water valve. Someone has cut a larger hole in the wall, apparently so that they could operate this valve from the closet side. To the left you see the hot water heater.
| |
| |
HWForums.com Message Forums
Copyright © 2001 HighWired Internet Innovations Inc. All rights reserved.