The Silver Streak E-mail ListArchive Files[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [SilverStreak] Re: [VAL] Shaver Pricing
I guess i just don't understand about all these rivet exchanges. I've done repairs on my 1958 Silver Streak clipper using a regular hand held rivet setter, then a pair of wire cutters to cut the nail-like piece that is left protruding out from the center of the rivet, and then i use a very file file to further smooth off the rivet head. I would challenge anyone to point out where these rivets are; as they perfectly match all the other rivets, both inside and outside. This process is a little time consuming but i have replaced/repaired rather large sections both side and under panels along with fabricating whole new walls on the inside. I share this for those that are looking for a less expensive way than purchasing a tool with very limited use. best regards, jim In a message dated 3/11/2008 6:14:44 P.M. Pacific Daylight Time, Eddie@Huffstetter.com writes: My copy and paste of the message skewed the price quote I will try to clean this up: -Eddie- Houston, TX Best Regards, Mike Hooper Phone: 1-800-325-3147 Fax: 972-786-0009 E-mail: mike@bylerrivet.com Hours: 7:30AM-4:30PM CST Mon-Fri. Price Each Byler Part # Description $180.00 497608 5B Olympic Shaving tool for 5/32 Dia. Shaveheads $000.195 14105050801 Shavehead Rivet: Aluminum 5/32 dia x .020-312 grip:no washer $000.20 14105050802 Shavehead Rivet: Aluminum 5/32 dia x .020-312 grip:with washer $210.00 497609 6B Olympic Shaving tool for 3/16 & 1/4 Dia. Shaveheads $000.23 14105060821 Shavehead Rivet: Aluminum 3/16 dia x .050-.500 grip: washer only $000.368 14105080801 Shavehead Rivet: Aluminum 1/4 dia x .050-.500 grip: washer only ************ All Purchases must me made through Mike Hooper w/ Byler Rivet Supply &**** ************must mention referral from Eddie @ Huffco to receive this pricing************ > From: Jason Parks > To: SSlist@TomPatterson.com > Date: Tuesday, March 11, 2008 12:05 AM > Thanks Eddie for all the great info. I did some checking today and have > come > up with the following pricing: > VTS - about $23 per 100 for Olympic rivets with washer > VTS - shaver tool - $209 > Thanks again.
|