RE: [SilverStreak] Braun

["Avalos, Danny" <Danny.Avalos@xxxxxxx>]

Eddie,

I still have my original hinges.  They do have some wear and I have
placed washers to make up for the wear but they appear to still be going
strong.  These new hinges will be bought as a backup so that when they
do fail I am covered.  Of course this is based on all of the horror
stories I am hearing about hinge failures.

Eddie I do appreciate your responses ealier on the gold trim question.
I figured it had to have been factory done but a good friend of mine who
got me into the SS thought that the gold was a signature SS thing and
that mine must have had it washed off at a later date.  Either way I
like it just fine with or without.

Thanks Again,

Danny  

-----Original Message-----
From: sslist-admin@tompatterson.com
[mailto:sslist-admin@tompatterson.com] On Behalf Of Eddie
Sent: Friday, June 06, 2008 10:12 AM
To: sslist@tompatterson.com
Subject: Re: [SilverStreak] Braun

Danny,
I moved your note to the Hinge Wish folder. If the price gets to the low

amount, I will buy an extra set to put a middle hinge on the doors of my

coaches. A middle hinge would match and look like was always there. It
would 
relieve the pull and stress on the skin, body and doors.
-Eddie-
Houston, TX

----- Original Message ----- 
From: "Avalos, Danny" <Danny.Avalos@cmc.com>
To: <sslist@tompatterson.com>
Sent: Friday, June 06, 2008 10:05 AM
Subject: RE: [SilverStreak] Braun


> Eddie,
> I want to add my name to the list for a set of hinges from Braun.
> Thanks,
>
> Danny
>
> -----Original Message-----
> From: sslist-admin@tompatterson.com
> [mailto:sslist-admin@tompatterson.com] On Behalf Of Eddie
> Sent: Friday, June 06, 2008 8:17 AM
> To: sslist@tompatterson.com
> Subject: Re: [SilverStreak] Braun
>
> Marc,
> Two projects are simultaneously happening on the list.
>
> One is logos. Tom Patterson is getting a count for that. The cost of
the
>
> logo for only the Silver Streak part is going to be $30 or less
> depending on
> quantity.
>
> Other is hinges. Eddie Huffstetter is getting a count for that. The
> hinge
> cost will be $100 or less for each piece. With quantity the cost can
be
> as
> low as #47 each piece. A "Wish List" count is needed to determine hand
> make
> or production run. People wanting new hinges need to indicate they
> "Wish" to
> have a set. That total count will be given to Braun before the end of
> next
> week. Braun works fast. The count will be very important.
>
> Your mint clipper should not be needing the hinges in project.
>
> -Eddie-
> Houston, TX
>