The Silver Streak E-mail ListArchive Files[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [SilverStreak] Info-Hinges and lenses
Ralph, Thanks. Curtis is looking at a site and maybe timeless travel will come up with something afforable? If we took stainless plate, had it break-bent to match, did the same to the door-in-door hinge, then grind shaped the mounting faces to match and drill exact match holes, why couldn't we take the correct size stainless pipe, weld it by short-arc to the now matching hinge plates and grind-cut the welded pipe on each to remove the sections needed to hinge and then use a 1/4" stainless pin? I have experience on 20 gauge stainless sheet and as thin as that was, it ground and polished all the welds beautifully including the orange heat colored burn areas back from the welds on the sheets. I made four pans or shelves, 12X24 inch with sealed welded corners. The sides were 2 inch.
|